Stock 5.0 Pushrod Specs.

89LXNB · 01-13-2001, 02:04 PM

1) Diameter, and tolerance +/- .00?
2) Length Dimension +/- .00?
3) Total runout allowable end to end. I have tools to check this.
4) Surface finish,Tiny nick allowable?
5) 600 grit okay to polish surface if nicks or scrathces must be removed completely?

Any input would help out.
Thanks,
Dan

fazali · 01-13-2001, 11:47 PM

------------------
2001 Mustang GT Blk/Blk
2Ch. 40 series Flowmaster Mufflers
K&N Air Filter

01-13-2001, 02:04 PM	#1
89LXNB Registered Member Join Date: Jul 2000 Location: San Jose CA Posts: 149	Stock 5.0 Pushrod Specs. 1) Diameter, and tolerance +/- .00? 2) Length Dimension +/- .00? 3) Total runout allowable end to end. I have tools to check this. 4) Surface finish,Tiny nick allowable? 5) 600 grit okay to polish surface if nicks or scrathces must be removed completely? Any input would help out. Thanks, Dan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Question about stock cam specs	MustangGT1990	Windsor Power	11	04-03-2002 10:04 AM
Pro-M on stock motor?	NotchJohnson	Windsor Power	3	03-23-2002 10:28 PM
Is a Ported Stock Intake Worth It?	Stang_Crazy	Windsor Power	9	09-28-2001 04:22 PM
5.0 stock cam specs?	Fostang	Windsor Power	1	05-16-2001 01:55 AM
LT's vs. shorties vs. stock headers	jonnyk	Windsor Power	9	01-01-2001 11:28 AM

01-13-2001, 11:47 PM	#2
fazali Registered Member Join Date: Jan 2001 Location: Plano, TX, USA Posts: 22	------------------ 2001 Mustang GT Blk/Blk 2Ch. 40 series Flowmaster Mufflers K&N Air Filter