© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-13-2001, 02:04 PM | #1 |
Registered Member
Join Date: Jul 2000
Location: San Jose CA
Posts: 149
|
Stock 5.0 Pushrod Specs.
1) Diameter, and tolerance +/- .00?
2) Length Dimension +/- .00? 3) Total runout allowable end to end. I have tools to check this. 4) Surface finish,Tiny nick allowable? 5) 600 grit okay to polish surface if nicks or scrathces must be removed completely? Any input would help out. Thanks, Dan |
01-13-2001, 11:47 PM | #2 |
Registered Member
Join Date: Jan 2001
Location: Plano, TX, USA
Posts: 22
|
------------------ 2001 Mustang GT Blk/Blk 2Ch. 40 series Flowmaster Mufflers K&N Air Filter |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about stock cam specs | MustangGT1990 | Windsor Power | 11 | 04-03-2002 10:04 AM |
Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
Is a Ported Stock Intake Worth It? | Stang_Crazy | Windsor Power | 9 | 09-28-2001 04:22 PM |
5.0 stock cam specs? | Fostang | Windsor Power | 1 | 05-16-2001 01:55 AM |
LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |