![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Oct 1998
Location: Suburban Chicago, Hanover Park
Posts: 695
|
![]() Besides the leak I mentioned in the other post I have rust bubbles starting on the underside of my pan. I want to replace the pan, but the pan I want is big bucks and I'm not sure how hard it will be to get at it. I understand I have to lift the engine to remove the pan, what is involved in this? Is it just a matter of loosening the engine mounts or is it more complex? Should I attempt this on my own or get it done at a shop? Anything I should do while I'm in there, such as new oil pump, windage tray or anything else? I don't really want to take this too far, but I don't want to waste the opportunity either. Hopefully I can stop the leak for this summer and replace the pan over next winter, but any suggestions, advice or tips would be appreciated. Any suggestions on particular pans? Canton, Moroso etc.?
------------------ 91 LX 5.0 Z t-5, 3:73 gear, Vortech 73mm Mass Air, Accufab 65mm TB, BBK underdrives, Crane HI-6S Ignition, BBK unequal length headers, Bassani x pipe, 2.5" Dynomax Super Turbo cat back, Kenny Brown Super Subs, Factory Five Control Arms, Mac cold air kit and more to come! |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Are long tube headers worth it on a basicly stock 5.0? | skiwesser | Windsor Power | 3 | 06-18-2004 08:26 AM |
TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
polishing stock parts? | scale | Windsor Power | 24 | 04-22-2002 11:57 AM |
Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |