Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-14-2005, 04:28 PM
|
#1 |
|
Registered Member
Join Date: Nov 2005
Posts: 1
|
Getting EEC codes with new heads/cam/intake install
Finally got my bbk ssi intake in and installed it this weekend along with edelbrock performers and E303cam. It seems to be running fine, but I am getting check engine light on. I did not rehookup my heater hose on the lower intake So now I am getting a code 98 and 51(Engine coolant Temerature sensor voltage). How can I fix this without hooking my heater pipe back up, and will this cause the computer to run in failure mode? These are the only two codes I am getting....
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| O2 codes at open loop? | Nixon1 | Windsor Power | 6 | 04-24-2004 08:43 PM |
| KOEO & continuous memory codes?? | Simi Stang | Windsor Power | 4 | 12-16-2003 02:37 PM |
| New Gears, Install, and Questions | B2r3y | Windsor Power | 6 | 02-21-2003 05:00 PM |
| Help with codes? | withamc | Windsor Power | 1 | 06-17-2001 10:22 PM |
| No Computer Codes = Bad Parts? (long) | slo95 | Windsor Power | 6 | 04-03-2001 09:03 PM |