how to run my belt?

RacingBryan · 05-21-2001, 09:55 PM

i was wondering on how i should run my belt i have manual steering, no ac, no smog? do i need to buy a older water pump? or which way does it run? thanks everyone

------------------
Bryan Thompson
1986 Lx Coupe
1992 5.0 engine, 2031 cam,trickflow intake, 24lbs injectors, 75mm promass air, crane 1.7 roller rockers, mac- equal headers, off-road hpipe, cat back exhaust, 3.55's w/disk, hurst shifter, t-5, NOS sportsman fogger setup w/8 wet foggers in a 1" spacer between upper and lower.

Mike_W · 05-22-2001, 12:27 PM

I put the power steering back on, but I had the same set up before. I drilled another hole in the alternater bracket, so I could rotate the tensioner, so the tensioner would be pulling up on belt, instead of pushing down. Hardly any belt surface was touching water pump, but it was good enough, plus the belt was extremly short.

------------------
90LX, T-5, Vortech V2-SQ, Holley, Twisted Wedge Stage1, X-303

05-21-2001, 09:55 PM	#1
RacingBryan Registered Member Join Date: May 2001 Location: Racine wi 53405 Posts: 11	how to run my belt? i was wondering on how i should run my belt i have manual steering, no ac, no smog? do i need to buy a older water pump? or which way does it run? thanks everyone ------------------ Bryan Thompson 1986 Lx Coupe 1992 5.0 engine, 2031 cam,trickflow intake, 24lbs injectors, 75mm promass air, crane 1.7 roller rockers, mac- equal headers, off-road hpipe, cat back exhaust, 3.55's w/disk, hurst shifter, t-5, NOS sportsman fogger setup w/8 wet foggers in a 1" spacer between upper and lower.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
351W belt routing	Ieatcamaros	Windsor Power	1	05-02-2003 08:15 PM
Timing belt (HELP)	Cora323	Small Ponies	1	02-01-2003 02:08 AM
short belt	89droptop	Windsor Power	2	11-20-2002 04:20 PM
What length belt with UD pullies	LowDown	Windsor Power	2	12-17-2001 08:21 AM
serp. belt	streetfreak	Windsor Power	2	10-02-2001 10:00 AM

05-22-2001, 12:27 PM	#2
Mike_W Registered Member Join Date: Apr 2001 Location: Sterling Hgts, MI, U.S. Posts: 64	I put the power steering back on, but I had the same set up before. I drilled another hole in the alternater bracket, so I could rotate the tensioner, so the tensioner would be pulling up on belt, instead of pushing down. Hardly any belt surface was touching water pump, but it was good enough, plus the belt was extremly short. ------------------ 90LX, T-5, Vortech V2-SQ, Holley, Twisted Wedge Stage1, X-303