MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 07-17-2006, 08:59 PM   #1
jammmm
Registered Member
 
Join Date: May 2006
Posts: 3
Unhappy A/C Problem - Electric or Vacuum?

My A/C is cold....but my switch to turn it from off to vent to A/C to Heat, etc. will only blow out of the Defrost and floor.

Okay....my center dash is out and the glove compartment is off. I can't find a vacuum leak anywhere. I've been told it may be an electric motor which switches the doors from vent to defrost. I really don't know.

Any suggestions? If it is a motor....where is it?

Thanks in advance for your help!
jammmm is offline   Reply With Quote
Old 07-18-2006, 10:26 PM   #2
grey88gt
Registered Member
 
grey88gt's Avatar
 
Join Date: Feb 2004
Location: Skiatook, Oklahoma
Posts: 193
Default Re: A/C Problem - Electric or Vacuum?

I had a vac line broken buy the fire wall on the passenger side, causing the same problem.
grey88gt is offline   Reply With Quote
Old 07-19-2006, 12:23 PM   #3
tmoss
Registered Member
 
tmoss's Avatar
 
Join Date: Mar 2003
Location: Saint Louis, MO
Posts: 634
Default Re: A/C Problem - Electric or Vacuum?

http://forums.mustangworks.com/attac...achmentid=5074

The vacuum lines from thje engine compartment can be broken, or if you've had your control panel out, the yeelow vacuum line can get pulled off the vacuum motor that changes the air from the winshield/floor to the dash vents.
__________________
Tom (Torque) Moss
88Gt 5spd Vert, FLowmaster Catbacks, stock cam advanced 4° @ 108.5° ICL, NMRA prepped GT40P heads 1.85/1.55 valves and 1.7 rockers, MAC P headers Jet-Hot coated, 97 Exlporer intake (ported lower), TB and injectors. 277RWHP/330RWTQ (SAE).

http://www.fastlanecars.com/
tmoss is offline   Reply With Quote
Old 07-20-2006, 12:00 AM   #4
jammmm
Registered Member
 
Join Date: May 2006
Posts: 3
Default Re: A/C Problem - Electric or Vacuum?

Okay.....Number 1 I did find the vacuum line inside the engine compartment. As luck, (or perhaps unluck), would have it, the line was broken in two. Unluck you say?? Well, I repaired the line and hooked it back up. Turned on the A/C and the air is still blowing out of the defrost and floor.

I did check the "yellow" line. It is in tact and connected properly.

What's next??

(By the way I followed the line from the engine compartment through the firewall and the line is in tact all the way.)

Need help...the 100+ degree days may shorten my life......(Not because I can't take the heat.....but because my wife may KILL me if I don't get the A/C working in more than one car!!)

Thanks again....in advance.
jammmm is offline   Reply With Quote
Old 07-20-2006, 07:27 AM   #5
tmoss
Registered Member
 
tmoss's Avatar
 
Join Date: Mar 2003
Location: Saint Louis, MO
Posts: 634
Default Re: A/C Problem - Electric or Vacuum?

you still have a vacuum problem somewhere in the line. That or the vaccum motor up there under the dash behind the control panel has a split vacuum diagphram, but that would be very rare. Remove the dash control panel and see if you have vacuum going to the vacuum motor's yellow line by pulling it off the control switch and put your finger or a vacuum guage on the nipple to see if it;s getting vacuum. If not, work back toward the engine caompartment from there.
__________________
Tom (Torque) Moss
88Gt 5spd Vert, FLowmaster Catbacks, stock cam advanced 4° @ 108.5° ICL, NMRA prepped GT40P heads 1.85/1.55 valves and 1.7 rockers, MAC P headers Jet-Hot coated, 97 Exlporer intake (ported lower), TB and injectors. 277RWHP/330RWTQ (SAE).

http://www.fastlanecars.com/
tmoss is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Well Damn..Vacuum problem Dark_5.0 Windsor Power 18 03-19-2004 01:49 PM
Electric water pump. Any problem w/ U/D pulleys? esandes Modular Madness 4 10-15-2002 09:58 AM
I'm ecstatic!!! - Vacuum problem solved!!! Question too. 2FastLX Windsor Power 4 09-19-2001 10:20 AM
Vacuum problem from the darkest depths of HELL - Part ... (I lost count) 2FastLX Windsor Power 3 07-16-2001 07:42 AM
Vacuum problem, I think? moponys Windsor Power 2 07-11-2001 10:06 PM


All times are GMT -5. The time now is 02:20 AM.


SEARCH