![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jan 2003
Location: Palm Bay, FL
Posts: 432
|
![]() Summit has a deal right now, 10% off your order, so I'm about ready to order my transmission and stall converter...it'll save me like $150... So the question is...what is a good stall speed for my combination in the signature? The car feels like it starts to make serious power around 3000...so I was gonna get a 3000 stall, but I'm worried about gas mileage. The tranny will be an Overdrive unit and I have a 4.10 rear. I use Overdrive constantly during city driving...I need to save all the gas I can. So of course, my rpms consistently fall to around 1500-1700 at cruise....how much slippage will I see at those rpms..will it be enough to slaughter my gas mileage? I get between 15 and 17 city right now. Thanks everyone.
By the way...would you recommend a B&M or a TCI Street Fighter stall converter? The transmission I'm getting is a TCI Street Fighter AOD.
__________________
'91 Mustang GT 5.0 AOD Daily Driver Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI 13.73 at 103.8, ~2.2 60' |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
302 Engine rebuild materials? | Tincan18 | Windsor Power | 5 | 04-25-2004 02:41 AM |
radar | stanger9219 | Blue Oval Lounge | 18 | 12-06-2003 11:26 PM |
warm start/idle stall, deceleration stall | mrrichard | Windsor Power | 1 | 08-13-2003 12:51 AM |
shift kit / 2500 stall | 50redvert | Windsor Power | 3 | 01-09-2002 12:49 PM |
Ready to replace bearings and install cam......What's a good spec?? | Stang_ROTY | Windsor Power | 16 | 10-23-2001 07:33 PM |