Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-10-2003, 09:25 AM
|
#1 |
|
Registered Member
Join Date: Aug 2003
Location: s. fl
Posts: 23
|
qeustions about installing guide plates.
Should they just bolt up or should I have to reem one of the holes out to make them fit? They have one round hole and one slotted hole but its not slotted enough. I was just wandering if anyone else has had to do this.
__________________
351w powered 86 gt with a reverse manual c4. Lots more but whos counting. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help woth installing groundpounder coilovers with BBK caster camber plates | ciara | Windsor Power | 0 | 01-10-2004 01:08 PM |
| best camber/caster plates | johnmcgt | Windsor Power | 3 | 06-11-2003 08:02 PM |
| Rail Rockers on 289 Small Block Heads | sleeperstang | Classic Mustangs | 16 | 05-11-2003 11:34 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| Motor Plates | mustangII460 | Racer's Club House | 1 | 05-11-2000 06:16 AM |