© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-06-2003, 03:51 AM | #1 |
Registered Member
Join Date: Aug 2000
Location: Wisconsin
Posts: 879
|
pushrod length? which one??
i mesured for correct pushrod length and came up with this..
7.650 the contact area was right in the middle of the valve stem..but it was a little bit bigger contact area 7.7 the contact area was a bit to the exhaust side but the contact area was smaller the engine is a 410W with victor jr heads and custom cam with 1.6 RR arms... what length do would be best for me to go with? also..these sizes seem small...BUT on comp cams site they list a pushrod for a 351W with retro fit hyd. roller as 7.7... any info and opinions and or input would be great...
__________________
'91 GT,410W,10.5 to 1 comp,Victor Jr. heads,Victor 5.8 intake,FTI cam,Crane retro fit lifters,Scorpian 1.6 RR's,Melling HV oil pump,MSD distro.,Canton oil pan,FMS flywheel,Romac balancer,FMS timing chain,Accufab 90mm TB,C&L 76mm maf, 42lbers,HD clutch,K&N air filter,Mac long tubes,Pro dumps,powerchamber,FMS 9mm wires,180 thermostat,Ford Racing gauges,5inch Tach,centerline convo pro's,nitto DR's,Pro3i lower control arms,50/50 shocks,3.55 gears,TFS HD diff. cover Next year: Tremec TKO,Spec stage 3 clutch,alum driveshaft,complete fuel system www.angelfire.com/linux/demondan |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Proper pushrod length? | Nixon1 | Windsor Power | 3 | 02-05-2004 02:36 PM |
Pushrod Length help | BLACK85GT | Windsor Power | 3 | 02-04-2004 10:27 AM |
AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |
pushrod length question/adjusting valve train preload | 84LX89GT | Windsor Power | 4 | 01-03-2003 03:59 PM |
Stock Pushrod Length | StreetRacin89Stang | Windsor Power | 4 | 04-17-2001 04:12 PM |