WC T-5 input shaft bearing

tarmon8r · 09-17-2005, 06:17 PM

WC T-5 part number 1352 249. The trans wouldnt shift into second or reverse and grinding into 3rd. Tranny is supposedly brand new. Took the trans apart to find out what i was going to need, gears, syncro's. Well, when i took the input shaft out, A bearing was ground up. It is the bearing inbetween the input shaft and the output shaft. The syncro's were fine, gears were fine. The syncros were not chewed up. I have already cleaned the case, countershaft, and what i could of the output shaft. I was unable to remove 5th gear. Did some minor clean up. It doesnt look like i need to replace anything other than the bearing i mentioned. Anyone know where i can get just that bearing?

mustangII460 · 09-19-2005, 07:41 PM

http://www.fortesparts.com/

If Mike doesn't have it, he'll know where to get it.

Call him, straight up buisness.

09-17-2005, 06:17 PM	#1
tarmon8r Registered Member Join Date: Jun 2002 Location: manassas, va Posts: 186	WC T-5 input shaft bearing WC T-5 part number 1352 249. The trans wouldnt shift into second or reverse and grinding into 3rd. Tranny is supposedly brand new. Took the trans apart to find out what i was going to need, gears, syncro's. Well, when i took the input shaft out, A bearing was ground up. It is the bearing inbetween the input shaft and the output shaft. The syncro's were fine, gears were fine. The syncros were not chewed up. I have already cleaned the case, countershaft, and what i could of the output shaft. I was unable to remove 5th gear. Did some minor clean up. It doesnt look like i need to replace anything other than the bearing i mentioned. Anyone know where i can get just that bearing? __________________ 1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided

09-19-2005, 07:41 PM	#2
mustangII460 Factoy Five Roadster Join Date: May 2000 Location: Sevier Co,Tennessee Posts: 1,681	Re: WC T-5 input shaft bearing http://www.fortesparts.com/ If Mike doesn't have it, he'll know where to get it. Call him, straight up buisness. __________________ Frank

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Input shaft ???? on T-5	lxnospower	Windsor Power	3	04-09-2004 12:20 PM
broken input shafts (plural!)	DrJaysBlown5.0Mod	Modular Madness	4	03-17-2004 01:54 PM
input shaft ?	WADS56	Windsor Power	1	08-26-2002 01:47 PM
Input Shaft	Phantom5oh	Windsor Power	10	05-31-2002 01:51 PM
play in T-5 input shaft.	jerryIII	Windsor Power	1	09-10-2001 10:40 AM