Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-17-2001, 01:58 PM
|
#1 |
|
Registered Member
Join Date: Sep 2001
Location: wappingers falls ny usa
Posts: 7
|
badge removal
how do you go about removing the badges properly and also if removed will there be holes left behind like my buddys F-250 thanks
|
|
|
|
09-17-2001, 03:57 PM
|
#2 |
|
Registered Member
Join Date: Aug 2000
Location: Plymouth, MI
Posts: 254
|
On the newer Mustangs, there will be holes left on the front fenders, since the badges have attachment pins. On older Fox-chassis cars, they were simply attached with adhesive. I filed the end of a balsa paint stirring stick, so it was pointed. Then slide it behind the edge of the emblem and gently pry it. The balsa is soft enough not to hurt the paint if you're careful.
------------------ Moxie Racing The Nitrous Oxide Information Site |
|
|
|
|
09-19-2001, 07:14 PM
|
#3 |
|
Registered Member
Join Date: Dec 1999
Location: Warrington, PA
Posts: 694
|
another way is too heat it up slightly w/ a blow dryer, and just pull fishing line behind it to get it off.
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5.8 cobra upper badge? | blk88lx | Windsor Power | 1 | 03-18-2004 08:35 AM |
| Windshield Molding Clip Removal | Kisner | Classic Mustangs | 7 | 04-30-2003 04:10 PM |
| Badge change - 5.0 to 5.4? | 302 LX Eric | Blue Oval Lounge | 11 | 02-05-2003 01:14 PM |
| 347 badge | Smokedawg | Blue Oval Lounge | 5 | 03-21-2001 12:46 AM |
| 5.0 Badge Removal | Smokedawg | Windsor Power | 5 | 03-20-2001 08:34 PM |