© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
Thread Tools | Rate Thread | Display Modes |
10-26-2001, 12:29 PM | #1 |
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
Welding in subframes and removing front sway bar . What should I run??
Right now I am running a 14.79 @93 @3000ft.I have subframes on the way and I am removing my front sway bar.
Right now my 60ft is 2.00. If I pick up any E.T. it should be in the first 60ft (I think) I have had people tell me that subframes make a night and day difference and I have had people tell me that subframes didnt help them at all. I for sure have a traction problem for the first 70ft I have to baby the car or it goes up in smoke. I am hoping for a 14.55 or so. ------------------ 88 mustang gt convertible bored to 306 BBk equal length headers, mac cold air fender kit, 3.73 FMS gears, Steeds Tri-ax shifter, Steeda underdrive pullies, Custom off road X-pipe, 2 chamber flow masters, cowl hood, nitto drag radials, ford racing clutch, 160* thermostat 16 degrees of timing electric fan off 94' t-bird jacobs electronics cap and wires. Edelbrock 1 1/2 inch drop springs. (Best E.T. 14.79@93mph @3000ft) |
|
|