© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-23-2001, 03:51 PM | #1 |
Backyard Mechanic/Chemist
Join Date: Feb 2001
Location: Acton MA USA
Posts: 435
|
Wiper problems Arrrgh
It took me a while to notice this problem since it did not rain for a while after getting my Notchback running. My wipers only function in the high position, the washer works but I have to turn on the wipers manually, when I switch to low, they stop dead. My 89 - 93 Chiltons manual has no wiring diagrams of the wiper system, I have the 79-88 version too, and there is partial info on a 87 system listing a module between the switch and motor. My motor has more wires than that setup. I would prefer to meter the wires first before yanking out the switch or motor, but I dont know what wires are supposed to do what??
Does the Factory service manual cover this??? I was hoping to fix this this weekend. ------------------ Frank W 90 5.0 LX coupe Daily driver. Silencer removed, K&N filter. Flexalite fan, 3 core radiator. FMS flywheel and Clutch Finally rebuilt T-5. 74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it www.chevellepages.com/folingo |
03-24-2001, 02:08 PM | #2 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
The brushes in the motor may be going bad or are dirty, mine did the same thing. Tap it gently with a hammer a couple times this will loosen everything up, I covered it with a rag so I didn't beat it up. It has worked for the last year and half. The next time it happens I'll go buy a new one.
Good Luck ------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! |
03-24-2001, 04:54 PM | #3 |
Registered Member
Join Date: Jun 1999
Location: Middlesex, NJ
Posts: 212
|
I just put a new motor in mine, it was doing the same thing. If i pushed down on the motor the blades would go, but not as fast as they should. The gears in the motor were too tight, and i couldn't fix it so I spent $40 and got a used motor from www.stangparts.com
Scott ------------------ 1992 GT 5.0L Convertible BBK Shorties Flowmasters All Power Super Chip |
03-24-2001, 05:21 PM | #4 |
Guest
Posts: n/a
|
I had it happen to my old mustang (87 notch 5.0), i beat it with a hammer just about everytime it rained, and then it just died one day, while it was raining. My advice is to just go buy a re-manufactured one. Its gonna go on you eventually.
[This message has been edited by Bangin Gears (edited 03-24-2001).] |
03-25-2001, 08:59 AM | #5 |
Backyard Mechanic/Chemist
Join Date: Feb 2001
Location: Acton MA USA
Posts: 435
|
Intersting, I would not have expected the motor to be bad since it does move on the high setting. Thanks for the info guys.
------------------ Frank W 90 5.0 LX coupe Daily driver. Silencer removed, K&N filter. Flexalite fan, 3 core radiator. FMS flywheel and Clutch Finally rebuilt T-5. 74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it www.chevellepages.com/folingo |
03-25-2001, 10:27 PM | #6 |
Backyard Mechanic/Chemist
Join Date: Feb 2001
Location: Acton MA USA
Posts: 435
|
Banged on the motor with the switch in the low position, and it started moving kept banging till it moved well. Noticed a rebuild sticker on the unit. Time to buy a new one, or should I get one from the boneyard?? I saw about 10 intact ones this weekend. My guess is get the rebuilt one since this may be a common problem
------------------ Frank W 90 5.0 LX coupe Daily driver. Silencer removed, K&N filter. Flexalite fan, 3 core radiator. FMS flywheel and Clutch Finally rebuilt T-5. 74 Chevy Laguna Type S-3 305 apart in garage, getting a 454 to put next to it www.chevellepages.com/folingo |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HELP: Problems after Paxton Novi 1000 install | Meatman | Windsor Power | 3 | 10-17-2002 06:03 PM |
Sick 88 Gt Computer problems? | ziggy_2k | Windsor Power | 5 | 06-02-2002 10:33 PM |
wiper delay problem | racer_inma | Windsor Power | 0 | 03-30-2001 02:27 PM |
Wiper problem | racer_inma | Windsor Power | 4 | 03-27-2001 09:44 PM |
67 windshield wiper problems | bmain | Classic Mustangs | 0 | 07-19-1999 03:19 PM |