© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-21-2003, 01:37 AM | #1 |
Registered Member
Join Date: Nov 2003
Location: Medicine Hat, Alberta, Canada
Posts: 9
|
What will this do?? Is it enough??
Hello everyone, new guy on the board here, I just have a question for ya. I would like to get a little more power out of my '95 5.0L (now keep in mind this is a daily driver). What I had in mind is to do the exhaust, leave the factory manifolds in place, remove the cats and go 2 1/2" mandrel bent with good flowing mufflers down both sides. Next is to do the computer, I was thinking of something fairly simple like a chip (what manufacturer or type I'm not sure) a little help here if you could. Lastly, I would like to put a cold air intake in. What kind of power gains could I expect from these mods??? And is there any other (not too expensive) mods that I could/should do? Again, keep in mind this is a daily driver. The car only has 29,000 miles on it if that makes any difference. Thanks for your advice
|
11-21-2003, 09:06 AM | #2 |
Gimme a Drink!
Join Date: Dec 2002
Location: NYC
Posts: 694
|
gears! 4.10 w/ auto, 3.73 w/ t5
__________________
1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong! |
|
|