Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-22-2001, 12:33 PM
|
#1 |
|
Registered Member
Join Date: Jan 2000
Location: Warner Robins, GA, USA
Posts: 210
|
Installing CATS in an off-road pipe
I just purchased a couple of high flow cats that I plan on welding in a BBK offroad pipe that I have laying around. Do you guys think it would be easier to weld them in before or after the pipe is installed? I realize the work will have to be precise if done before installation in order for it to line up correctly. I would be easier to weld out of the car. Also, do stainless wire/rods have to be used when welding stainless to aluminized steel? Thanks for any feedback, I hope to do this on Saturday.
------------------ '97 Cobra, Rio Red, MAC Cold Air Kit, 3.73s, NGK V-Power |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| X pipe, off road or catted? | 06Stang | Modular Madness | 3 | 10-21-2003 04:59 AM |
| Hi flow cats X/H pipe??? | chuck88 | Windsor Power | 3 | 12-04-2002 07:06 PM |
| Off road pipe vs. Catalitic Pipe | Kamaro Killer | Windsor Power | 7 | 04-04-2002 04:05 AM |
| Mac H pipe w cats vs BBK x pipe with cats?? | Chevyguy | Windsor Power | 15 | 11-16-2001 08:34 AM |
| 2 chamber Flow with Off road H pipe | evilmustang | Windsor Power | 2 | 06-19-2001 08:13 AM |