Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2001, 11:48 AM
|
#1 |
|
Registered Member
Join Date: Sep 2000
Location: Brampton, ON, Canada
Posts: 298
|
Check Engline light after O2 replacement
Hi,
Last Friday I got my O2 sensors replaced. I was surprised as to what my old sensors were; one was the stock OEM, and the other was a Bosch (both 3-wire). I replaced them with two Bosch (part #13942). Anywho, since getting them installed, car didn't feel right so I unplugged battery for about 20min to let the computer reset; after that, the car idled like crazy on a few occasions (it died on me twice, and third time it idled at 700rpm for about a minute and then suddenly died). Since replacing the sensors I've put about 90KMS (62 miles), and I think the car's starting to drive better. So question is, is this normal? How long should it take for the car to break into the new sensors? Thanks! Bye! ------------------ Gautam N. Lad http://www.cubicdesign.com http://www.cubicdesign.com/mustang/ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| Check Engine Light | 96GTPRT | Modular Madness | 5 | 05-20-2002 07:48 PM |
| check engine light after long tube install | tomazzzo | Windsor Power | 8 | 02-19-2001 05:49 PM |
| Now What??!! - Check engine light just started coming on... please help. | AxemanZZ | Windsor Power | 4 | 02-01-2001 03:00 PM |
| Check Engine Light? | Maxi 5.0 | Windsor Power | 3 | 01-09-2001 10:50 PM |