© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2001, 03:53 PM | #1 |
Registered Member
Join Date: Dec 2000
Location: slidell, La
Posts: 73
|
T-5 Bearing Retainer
I already have my t-5 out since i'm changing my clutch and was wondering if I should get a steel bearing retainer for my trans. What would be the advantage of this??
|
03-19-2001, 04:00 PM | #2 |
Registered Member
Join Date: Jan 2001
Location: elgin ,iL,USA
Posts: 36
|
Yes I would since you already have the trans out. the steel wont wear as much and the stock one is more prone to fail
|
03-20-2001, 01:16 AM | #3 |
Registered Member
Join Date: Mar 2001
Location: San Diego, CA, USA
Posts: 86
|
what are the symptoms from a bad bearing retainer?
my tranny or diff are acting up. |
03-20-2001, 12:07 PM | #4 |
Dirk Diggler
Join Date: Feb 1999
Location: SLOATSBURG, NY
Posts: 1,931
|
visuak inspection of the old retainer should tell..usual symtoms are frequent replacement of trwoout bearings or more pedal pressure than usual cuz the throwout cant slide as well on it
------------------ 1987 black notch(ex 4 banger) DSS 306 w/ main support...Elderbrock 6028 heads..gt-40 intake..24# injectors...70 mm tb..77 pro-m...accel 300+..mac full legnth..tremec w/ pro5oh...full MAC exhaust,off road h-pipe,long tubes, catback...ron davis radiator..subframes, control arms...CFDF II..o yea holley FPR sucks..dont buy one.. AIM=onesillynotch |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
T5 hard to shift after replacing bearing retainer | Merlin76 | Windsor Power | 8 | 02-20-2004 10:22 PM |
Stock steel bearing retainer? | Merlin76 | Windsor Power | 1 | 04-13-2003 08:42 AM |
Need advice on throwout bearing | RPM427 | Windsor Power | 2 | 08-28-2002 02:05 PM |
Shakey from the start?¿ | GreenPony | Windsor Power | 13 | 02-11-2002 08:53 AM |
Steel Bearing Retainer! | Cannon | Windsor Power | 6 | 05-22-2001 07:16 PM |