Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-08-2002, 12:00 PM
|
#1 |
|
Registered Member
Join Date: Mar 2001
Location: college station, tx
Posts: 143
|
Milling Heads Q
My heads are off right now and am getting new valvesprings today. So I figured what the heck...I'll have them milled. I have a .513/.529 cam, so can I mill them about .040 to bring the chambers down to 57 or so and bump compression to about 9.6-9.7? I want to go as much as I can but without having any P/V or intake sealing or port alignment problems. Thanks.
__________________
Clint L. White 95 Cobra #3637 64cc GT40X heads with mild porting, Crane 2031 cam, FRPP 65 TB, 1.7s, Cobra intake, homeade cold air, 155lph, pullies, Tokico Illuminas, C springs, GW LCAs, Kenny Brown super subs, Steeda CC plates, aluminum driveshaft, Steeda quadrant, B&M ripper, Kirban FPR, MSD6A, Taylor wires, Mac shorties, off road hpipe, 2 1/2 ultra flows w/ dumps, R hood, Euro clear corners, stock 3.08s 13.61 @ 105.7 w/ 2.22 <-- 284 rwhp / 323 rwtq |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| What kind of Windsor heads? | vetteeatr | Windsor Power | 11 | 10-28-2001 03:43 AM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |