Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-31-2002, 01:30 AM
|
#1 |
|
Registered Member
Join Date: Nov 2000
Location: Maple Ridge B.C. Canada, The Best Place In The World
Posts: 871
|
Could My Heads Be Milled Or Something???
I did a compression test just a couple months ago, and my compression was at a 148psi low, and 158 high.
I have been told by lots of people a stock 5.0 is around 140 stock. Oh, BTW I have 110000 miles on the clock, so its well worn.
__________________
1984 Bronco II, 36" Michelin Military Tires, 95 EFI 5.0, NP435 Tranny, NP208 Doubler, NP205 Transfer Case, Fill Size Solid Dana 44 Front End, WH Progressive Rate Rock Crawling Coils, Bronco 8.8 Rear, Skyjacker Softride Leafs, 5.13 Gears, Detroit Locker. Final Crawl Ratio Of 175:1 88 GT Best 60ft. 2.181 Best ET 14.350 Best MPH 98.01 ~WRECKED!!!!~ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Milled heads and 347 CI swap | eatsgmcar | Windsor Power | 2 | 08-10-2002 11:08 AM |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| Help with heads, what to do???? | HiFlow5 0 | Windsor Power | 5 | 07-14-2002 06:22 AM |
| What kind of Windsor heads? | vetteeatr | Windsor Power | 11 | 10-28-2001 03:43 AM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |