Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-22-2002, 12:23 AM
|
#1 |
|
Registered Member
Join Date: Dec 1998
Location: Hatteras,NC,USA
Posts: 108
|
Old Block, New Heads
I have a non roller cam block that I want to use stock 87-93 roller cam heads on, what pushrods do I need and how about the rockers? I will have the valve relief forged pistons installed, and have heard about a roller cam conversion you can buy, how does this work? the lifter hold down tray would have no place to screw down unless to drill and tap some holes?
__________________
86 GT, March Pulleys, Off Road H-Pipe, Ultraflow/Mac Tailpipes, 3.73 gears/ AOD to T-5 Conversion/ Motorsport Wires/ Trick Flow Heads BBK headers/ F Cam/ Forged TRWS/ Cobra Intake Mass Air conversion, Bored .40 /1.6 Motorsport rockers |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 71 2v Cleveland heads on a mild 302 | crazypete | Windsor Power | 3 | 06-18-2004 07:05 PM |
| Need help deciding on an engine block!! | 93 Cobra needs input | Windsor Power | 6 | 10-23-2002 05:29 PM |
| What makes a Small block a Small block and a Big Block a big block? | gtsr515 | Windsor Power | 13 | 05-20-2002 10:25 PM |
| TFS or Yates Heads on stock block??? | Stang Runner | Windsor Power | 4 | 08-18-2001 02:19 PM |
| Get your 4.6 PI heads while you can... | 91LX2Bfast | Modular Madness | 1 | 12-01-2000 01:52 AM |