

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: May 2000
Location: Kamloops, BC
Posts: 2,875
|
![]() Ok I got myself a compression test kit. It was only $42 (Canadian
![]() Both #4 and #8 are a B!tch to get the fitting in, but I did get them in eventually (after a few...many...choice words). Cylinder# Pressure 1 152 2 150 3 145 4 145 5 140 6 145 7 146 8 149 I got the car warmed up and stared to take things off. I removed the front brace and cold air ducting. I then removed all 8 wires then all 8 plugs. I checked the gap on most of them. It was between 0.050 and 0.055. I started at #1 and went to #8 (well I actually skipped #4 and came abck for it after #8) The car had cooled down some (it took some time to get #4 and #8) but even at the end the adapter was almost too hot to hold. I cranked it over 5 times on each cylinder. I started thinking about the gas smell, could I just have a screwed injector? Or maybe a crack in the intake manifold? Well I hope this is enough to generate some ideas. |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Looking to buy and I need Advice...Fuel Pressure Test Gage and Compression Test Gage | MTU 50 | Windsor Power | 3 | 10-18-2002 05:34 PM |
C&L Mass air question and compression results & question. | Agent_4573 | Windsor Power | 7 | 07-28-2002 07:10 PM |
PKRWUD: Fuel Pressue Test Results ?? | 95mustanggt | Windsor Power | 8 | 07-17-2002 01:11 AM |
Cold compression test? | 92Rustang | Windsor Power | 3 | 12-17-2001 09:47 PM |
Leak down test results. | chris91LX | Windsor Power | 1 | 12-14-2001 02:16 PM |