Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-23-2002, 08:16 AM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Fuel gauge
I just got my fuel level gauge mounted in the pillar. Now I need to wire it up. Can I use the wires from the factory gauge cluster or do I have to run new wires?
It looks like either way will be about the same amount of work, but if I have to remove the gauge cluster, I might as well send of my speedo now (I have 3 spares) to get the white face gauges and 140MPH conversion.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fuel gauge install | GhettoPop | Windsor Power | 4 | 01-23-2004 01:41 PM |
| Fuel Gauge Problem? | Philossifer | Windsor Power | 9 | 08-23-2003 10:08 AM |
| fuel filter/gas gauge | Lonzo | Classic Mustangs | 1 | 07-30-2002 10:33 AM |
| Fuel Gauge install questions | Chipdog | Windsor Power | 0 | 08-12-2001 07:06 PM |
| fuel gauge went dead..fuel sender? | Beni | Windsor Power | 1 | 06-09-2001 02:44 AM |