Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-07-2003, 12:34 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: Fernandina Beach, FL 32034
Posts: 178
|
Hypertech Chip
Has anyone had any experience with a hypertech chip. My car is a 90 LX convert w/ AOD mostly stock, exhaust and cold air. The chip seemed to help part throttle but seemed very rich. I check fuel and sure enough was at 43. Put on kirban adj. reg and set pressure at 39. Much better but lost top end and pings slightly ( timing only at ten) and still rich at idle. Am I better off without chip and set timing back to 14 now that fuel pressure is correct. Any ideas?
Bill
__________________
Bill Heiser 90 Convertable 5.0 LX, ported E7s w/ THumper valve job, TFS street, FR 65mm TB, B cam w/1.7 cobra rockers, kirban AFPR, Mac CAI, Mac Headers, off road h, 3 chamber flows, Crane ign. box, 3:73s, Art Carr AOD & 2600 converter |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chip Vs. Programmer | xxxBlakexxx | Modular Madness | 18 | 12-30-2004 06:03 PM |
| Diablo Chip Test | xxxBlakexxx | Modular Madness | 17 | 03-24-2004 05:37 AM |
| Which Chip is Best? | xxxBlakexxx | Modular Madness | 1 | 12-28-2003 04:04 PM |
| Hypertech chip and timing ?? | withamc | Windsor Power | 6 | 06-21-2001 08:03 PM |
| Is chip needed when changing to 3.73's? | bark3rd | Modular Madness | 11 | 04-05-2001 11:21 AM |