Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-30-2003, 12:44 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Roll cage painting
What is the best type of gun to paint a roll cage? I was thinking of using an airbrush, but even with the tip at its widest, it will take a long time to pain.
By the way the car is a coupe, you can see pics of it on my site, just follow the link in my sig and go to Scotrod cage page.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Roll cage painting | Stang951 | Appearance & Detailing | 0 | 04-30-2003 12:47 PM |
| Roll cage install ...a few questions | Fox Body | Racer's Club House | 2 | 07-15-2002 04:41 PM |
| NHRA Legal Roll Cage? I need one! | cyberstang5.0 | Windsor Power | 2 | 05-05-2002 06:57 AM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |