Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-30-2004, 02:09 PM
|
#1 |
|
Registered Member
Join Date: Oct 2003
Location: Fayetteville NC
Posts: 12
|
Hammer shifter adjustment help
I recently purchased and installed a B&M Hammer shifter. The install went well, but I cant seem to get it to go completely into park. At first It wouldnt go into park at all (the reverse lights would come on when the shifter was in Park) and the manual said to get a new cable from ford. I purchased a new one from ford and now when the shifter is in park, the reverse lights are out, but the tranny must not be in park all of the way so it wont start. I crawled under the car and adjusted the cable to the tranny as directed by B&M but still nothing. If I push on the cable where it is attached to the tranny, the car will go into park far enough to start it, but once I run through the gears I get back to square one.
I appreciate any and all help or suggestions on this matter!! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No Need for Aftermarket Shifter after this Mod !! | Katmandu | Windsor Power | 6 | 03-24-2004 06:07 PM |
| Anyone ever install a B&M hammer shifter in there AODE 4.6 GT?? | 96_4.6 | Modular Madness | 15 | 08-24-2003 12:43 AM |
| what would you ask for for christmas?? | lx5091 | Windsor Power | 28 | 11-22-2002 10:52 AM |
| B&M Hammer Shifter???? | Green9550 | Windsor Power | 10 | 05-16-2002 04:10 PM |
| B&M Hammer shifter..... | 88COBRA | Windsor Power | 10 | 02-01-2001 01:17 AM |