

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jan 1999
Location: Farmingdale, NY
Posts: 139
|
![]() Hi everyone,
Not too long ago, I posted a thread on a problem I had at cold start. My 93 GT will start and then stall. After getting it to start propertly (giving it some gas..) it would hesitate and jerk a bit during driving. The idle would also be choppy too. But one it was warm, the problem would go away. It was suggested to change the ECT, ACT sensors and look into the 02 sensors too. Well, I popped in new ECT, ACT sensors and even a new EGR valve (the guy at the DMV told me I was failing the NO on emmissions). I'd figure the 02 sensors are ok since I just replaced them about 1 year and half ago. I also replaced the distributor cap, checked plugs etc. Well...after all these replacements, the problem hasn;t gone away! FYI, no 'Check Engine' lights go on, all the diagnostics appear to be ok. I did have problem scanning the EEC-V, but I probably ended up with the wrong scanner anyway. Could anybody give me any other suggestions on what could the problem be? The mechanics down the block insist it's the 02 sensors...Could it be a compression problem? Need some feedack! Ciao!
__________________
1993 GT, MAC Fenderwell Cold Air Induction; Accel dist.,Splitfire plugs, BBK: 1 5/8 unequal length shorties, hi flow H-pipe w/ cats; Flowmasters 2 chamber American Thunder catback system, Motorsports 3-core radiator, 180º thermostat, BBK adj. clutch quad...the rest is bone stock!..but more mods to come!! |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
warm start/idle stall, deceleration stall | mrrichard | Windsor Power | 1 | 08-13-2003 12:51 AM |
Good Stall Speed? | Nixon1 | Windsor Power | 0 | 07-24-2003 12:25 PM |
Launch Rpm Vs. Stall Speed | ciara | Windsor Power | 2 | 02-16-2003 10:20 AM |
Anyone have advice on 393 stroker camshafts & stall speed? | Stang_ROTY | Windsor Power | 4 | 04-11-2002 03:34 PM |
Dont 99+ GT's have Alunimum drive shafts? | Mercury | Modular Madness | 5 | 05-15-2001 12:33 PM |