Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-10-2005, 12:24 AM
|
#1 |
|
Registered Member
Join Date: Sep 2000
Location: rock hill,S.C. 29730
Posts: 420
|
Q: about fel-pro loc wire gaskets
Does the block have to have the ring machined as well, or just the heads?
__________________
88 GT: subs,pullies, 1 3/4 longtubes, flowmasters, AFR 165's,T,F #1 cam,Thyphoon intake, 24# inj., 73mm C&L,65mmT.B., 190LPH pump, Eagle sir rods, forged pistons in a newly rebuilt 306. DYNO TUNED TO 300.97 RWHP 337RWTQ |
|
|
|
10-10-2005, 06:32 AM
|
#2 |
|
Registered Member
Join Date: Feb 2005
Location: Wolcott, CT
Posts: 6
|
Re: Q: about fel-pro loc wire gaskets
I've read that the heads are cut .007", but the block isn't.
John |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire route for aftermarket amp in '95 | The Jester | Audio, Security, & Electronics | 3 | 04-17-2005 05:49 PM |
| HEGO orange wire grounds to manifold?? | Simi Stang | Windsor Power | 2 | 12-19-2003 08:13 AM |
| again, How to cure code 66 (maf below minimum voltage) ???? | HAITHAM | Windsor Power | 6 | 11-12-2001 09:10 AM |
| Fel-Pro Loc Wire gaskets | 84_GT350 | Windsor Power | 1 | 06-15-2001 07:46 AM |
| Gaskets - Which ones and where do I get them from? Please help quick. | 2FastLX | Windsor Power | 1 | 03-14-2001 12:08 PM |