Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-15-2001, 01:19 PM
|
#1 |
|
Registered Member
Join Date: Nov 1999
Location: Abilene TXUSA
Posts: 104
|
Roll Cage
Has anybody built there own? I have access to a bender and a notcher, and can weld good enough to get it to a shop to have the final welds put on. Do ya'al think it is worth it, or am I going to spend more on raw materials than I can buy one for? Thanks for the input.
Keith ------------------ 90 Lincoln LSC/90Gt,Roller 302 with 54cc 289 heads;Ported Lower,Cartech;MSD;Accel; Motorsport;Autometer |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Roll cage install ...a few questions | Fox Body | Racer's Club House | 2 | 07-15-2002 04:41 PM |
| NHRA Legal Roll Cage? I need one! | cyberstang5.0 | Windsor Power | 2 | 05-05-2002 06:57 AM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| ROLL CAGE vs. NJDMV | RMARIANI | Windsor Power | 8 | 02-09-2001 06:49 AM |