Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-10-2006, 08:22 AM
|
#1 |
|
Import Slayer
Join Date: May 1999
Posts: 2,241
|
Installing new Edge converter....finally!
I finally got the time to start installing my new 3700 stall converter from Edge.
How much fluid should I put in the converter? I've heard from 1/2 quart up to 3 quarts already and I want to be sure what's the correct amount. When I put my 2400 stall converter in about three years ago, I only got about 3/4 of a quart in it. How important is this step? Also, this is the first time I installed a tranny without it attached to the engine. Is there any good advice out there?
__________________
'82 GT 351W (.060)Comp Cams 274* Extreme Energy cam, ported & polished heads w/ 1.94/1.60 valves 10.3:1 flat top pistons,stealth intake, Mallory dizzy,Holley 750dp carb, BBK shorties,Flowmaster exhaust,C-4 with 3700 stall converter, B&M pro shifter,8.8 rear, 4:10's, subframes, electric fan, powermaster alternator, 4 core radiator. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Torque Converter Install and Question | Red5Ltr | Windsor Power | 41 | 07-09-2004 01:50 PM |
| Another "which stall speed conv" thread! | crazypete | Windsor Power | 8 | 10-10-2003 02:45 AM |
| Torque Converter Lockup Q | Nixon1 | Windsor Power | 3 | 02-14-2003 03:00 PM |
| Whats the best Torque Converter | Brady91 GT | Windsor Power | 6 | 06-21-2001 12:42 AM |
| code 628 - Excessive converter slippage??? | slo95 | Windsor Power | 7 | 05-05-2001 01:18 PM |