Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-06-2005, 02:07 PM
|
#1 |
|
Registered Member
Join Date: Jun 2000
Location: Pigeon Forge Tn
Posts: 611
|
Steering question
Can you just replace the inner tie-rod ends and reuse the outers?
I was working on the 93 today, and while it had one wheel in the air, I tried the old "tugging on the tire". She has been "wandering" for a while now, but I havent realy had a chance to dig into it. Last time I checked, it seemed ok, but... Anyway, the driver side has about 1/4 inch+ flex with the other tire unmoving on the ground. (I Imagine the other side is in the same shape due to the wear on the tires. Didn't have time to verify.) The outer rod seemed ok, and I didnt have time to pull the dust boot. Basically, my question is would it be a bad thing just to replace the inner rods, without doing the outers? Money is, as always an issue, since a new set of tires are on the horizion too, but I dont want to chew them up prematurely. Thanks for any advice in advance, J
__________________
____________ '66 Mustang Coupe- AKA "Lenore" *on disability for a (long) bit* '93 GT Mostly stock AKA "Fawkes" Rice Haters Club Member #239 "I find your lack of faith...disturbing." "Every normal man must be tempted at times to spit on his hands, hoist the black flag, and begin to slit throats." H. L. Mencken |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Steering Question | Stang_ROTY | Windsor Power | 0 | 07-27-2004 05:54 PM |
| Manual Steering Question.. | streetracinchik | Windsor Power | 9 | 08-19-2003 08:15 AM |
| steering question | digital3.3 | Small Ponies | 0 | 10-24-2002 11:39 PM |
| Quick question!! Need help fast please!... Steering wheel question!!!... | WA2FAST | Windsor Power | 3 | 02-14-2002 02:41 PM |
| Tilt steering question | RPM427 | Windsor Power | 3 | 12-26-2001 08:14 PM |