Steering rack issue... question
 

We just got a new faster ratio rack for the '89 and it is a little different. The diameter of the mounts is smaller than the original. Here is a pic for comparison:

http://mywebpages.comcast.net/joevit...ck_comparo.JPG

The mounts on the K-member are too big to fit the new rack's mounting holes. Has anyone seen this before? What should be done?

Thanks all...

Re: Steering rack issue... question
 

Yes, have dealt with it every time I do a rack on a Fox Mustang. The bushings supplied with the new "jobber" racks are from a Mustang II. You have to reuse your old sleeves and bushings from the old rack or order new ones. Just pop them out of both racks and install the originals in the machined hole in the new one.

Re: Steering rack issue... question
 

thank you my brutha, I appreciate the info. I was going to do that, I just wanted to check with you guys to make sure that that was the case...

Thanks again!!!