01-18-2001, 05:39 PM
| #1 (permalink) |
| Registered Member Join Date: Jan 2001 Location: sandston, va.
Posts: 12
|  Stock axles?? Sorry but i need some help!! About 8 months ago my driver side axle bearing started to howl pretty bad so i took everything apart and noticed the bearing was bad and the axle was a little scared. Well i figured i would be upgrading soon so to make it last i would just replace the bearings and seals in both sides. Well now it is making noise again and it is getting worse by the day. I know my axles are shot but i don't have the money for mosers or anything, does anyone have any that are in good condition that they are willing to give me or sell to me for a relatively cheap price?? I will pay shipping. Please help me if you can, i would prefer both axles but if not then at least the driver side. Thanks!! Jarrod |
|      |
|
01-18-2001, 06:19 PM
| #2 (permalink) |
| Moderator  Join Date: Aug 2000 Location: Milan, OH
Posts: 2,699
|  I would bet that you could find them in a local boneyard for a hell of a lot cheaper than shipping would cost you for a pair. If not, check with a local speed shop that does Mustang work. They've more than likely pulled more than their share for upgrades and have the stock ones laying around collecting rust. ------------------ Jeff Chambers Trophy Stock #3 11.97 Seconds / 114.5 MPH Chambers Racing Team |
|
| |
| Sponsored Links | |
| | |
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drag rad. and stock axles | explicitone | Windsor Power | 8 | 07-18-2002 08:45 PM |
| Anyone pull sub-1.7 60ft's on stock axles. | Dark_5.0 | Windsor Power | 3 | 06-18-2002 04:03 AM |
| bbk unequals and stock H pipe :( | scale | Windsor Power | 4 | 06-14-2002 12:41 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 02:53 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |
Linear Mode
