stock Head question
 

I got a set of stock E-7s that are milled .030.. the cumbustion chamber size WAS 65cc does any one know what the new size is????

------------------
ALL NEW PPG Torch Red 95GT, 304ci block, Forged pistons, Ported Explorer Intake, E-303 cam, fully ported and polished and milled E-7 heads, 75mm MAS, BBK Adj. fuel Reg & gauge, BBK Shorty Headers, BBK H-pipe, March Pulleys, 2 Chamber Flowmasters, Kenny Brown 6 point Roll cage, Kenny Brown Panhard Bar, Powerslot Rotors, PBR twin piston calipers, Eibach Sportline Springs, 180* Thermostat, 1/2 Plenum Spacer, MSD 6AL, MSD Master Blaster, MSD 8.8 Wires, 24# Racing Injectors, AFS 10.5" Cobra R's, Nit

I'd say prolly around 62cc.

------------------
Dustin
Saleenized 89 GT,428 rwhp,TFS Street Heat Intake,TFS TW Heads,TFS #2 cam,BD-11A 9 psi,FRPP 1.6 rr's,BBK 70mm TB,Pro-M 75mm Bullet,MSD 6BTM, FMS 9mm wires,BBK longtubes,BBK Short H-pipe,American Thunder cat back,3.55's

12.3@119

Any other guesses. i would like to try and figure out the Compression ratio, cuz allot of people are thinking it is around 11:1 cut the block was deced too...