Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-17-2002, 10:59 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Stroker Motor or not ?
I am in the planning stages of building a new motor for my 85 GT.
I am mostly gonna use it for fun at the 1/4 mile track and light street use. My question is about stroker motors. I do not have any experience with them and was wondering what are the positives and especially what are the negatives of building and running this type of engine. Also should i go with a 302 or 351 block. I was planning on using the TFS TrackHeat heads, TFS #2 Cam, TFS forged pistons, full roller motor., Carb with Perf RPM Intake. I am hoping for 375 to 400 HP at the flywheel.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a stroker motor | Mustang_289 | Windsor Power | 4 | 02-17-2005 12:46 PM |
| Blown Stroker Computer Help | RabidPony | Modular Madness | 10 | 02-07-2004 11:56 PM |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| 351w or 347 stroker? which is better? | BLACK85GT | Windsor Power | 55 | 12-21-2002 06:52 PM |
| Decided to build a stroker, but where do I start? | WhiteLX | Windsor Power | 5 | 12-16-2002 10:35 AM |