Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-17-2003, 11:59 AM
|
#1 |
|
Registered Member
Join Date: Mar 2003
Posts: 32
|
Cylinder Head Questions
My car is set up for autocrossing where I stay mainly in 2nd gear and spin around 5500-6200 rpm at the most. Currently i'm running an E cam, stock 87 intake, and stock heads with Trick Flow valve springs. Question is I would like to stay with stock heads and do work to them like porting, screw in studs for hardened pushrods, would this be sufficient for this? And would the 2.02 valve heads be a little much for this and needing the bottom end torque?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 12:28 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |
| Cylinder Head Swap | Fostang | Windsor Power | 0 | 05-05-2001 09:51 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |