swapping brake lines to a 8.8
 

When swapping the brake lines from a 7.5 to a 8.8 axel, what do I do with that little brake line diversion block on the passenger side of the 7.5 axel. If I move it over to the 8.8 will this be in the way when converting to a true dual exhaust?

Thanks.....

You can safely move that over. I have true duals on mine and it has enough clearance. Mine is an '83 GLX.

Phanom

------------------
CHECK OUT MY MODS

http://www.mustangworks.com/cgi-bin/...splay.cgi?1350

Mine clears my MAC tailpipes, I just bouight some heat shielding sleeves and covered the lines to make sure the tailpipe doesn't burn it.

------------------
GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!