t-fitting for 2 oil pressure sending units in stock location
 

i replaced my stock oil pressure sending unit, which is located next to the oil filter, with a new autometer unit and electric gauge. works great but i want to get the old stock gauge working again. i assume i need some type of t-fitting to get both sending units on there. is this the only way to do it? will both units/gauges read accuratly? and most importantly, does any one know the exact size of the fitting i need?

Re: t-fitting for 2 oil pressure sending units in stock location
 

It will work fine. I deleted the stock one, but added an oil temp with t fitting off the same port.

Re: t-fitting for 2 oil pressure sending units in stock location
 

do you know what sizes were on the ends of your t-fitting?

Re: t-fitting for 2 oil pressure sending units in stock location
 

They should be 1/8" pipe.