Thermstat selection, putting in today....
 

Finally replacing a few things here and there today, and was wondering what Thermostat should I get, Stock, 180, etc? Any suggestions.

I am going to the parts store in a couple of hours so any replies are appreciated.

Kevin

------------------
91 LX Convertible Gray on Red B&M Shift improver kit,ASP red alum. underdrive pulleys, Richmond 3.73 gears, 1 5/8 Flowtech long tube Headers and off road h-pipe, Flowmaster 2-chamber cat-back with S.S exhaust, MSD 6A Ignition with coil,Cap and rotor, Taylor Pro wires, K&N 12" conical filter system, Jet stage 2 performance chip,GT40 P heads, looking at new exhaust, Lentech Street Terminator plus.

if your car has been getting warmer than it should than go to the 180. if it isnt haveing any cooling problems than the stock replacement should be fine.
if you plan more mods in the near future, go ahead and get the 180.
just make sure it gets warm enough with the 180 as a too cold engine is not a good performing engine! (and not good for it either)
Q

------------------
Quin, 87 GT,306,forged/cut pistons,edelbrock head\intak,steeda#18cam,1.7rr,MSD Blaster tfi coil,A9L,pro-m75mm,24#inj,accufab65mm,2.5"pipes,hooker headers,dynomax exhaust,3.73 gr,110 lph fp,180*therm,moroso cold air,ASP pullies, weld rims

See my engine on user rides.

I see your shwartz is as big as mine, now lets see how well you handle it!