Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2002, 10:02 AM
|
#1 |
|
Registered Member
Join Date: Oct 1999
Location: new windsor,ny
Posts: 75
|
are these good heads (C90E's)?
i am looking getting a set of heads that have a casting number of C90E. i was told that they are 1969 castings and have been ported and polished,new valve guides and seals,FMS valves,springs, locks, and retainers, and have been hot tanked and fluxed. supposedly will flow better than the gt-40's.
is anybody else using these heads, and what do you think of them? thanks
__________________
650 Holley DP,Flowmaster American Thunders,H-pipe,American Racing rims, short throw shifter, T-5 , Zoom clutch, Dynagear timing,Kenwood stereo,FMS sparkplug wires,GTS smoked light covers |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Price estimate for barely used Edel. Perf. RPM alum. heads w/ 2.02/1.60 valves?? | Simi Stang | Windsor Power | 13 | 11-03-2003 11:23 PM |
| 351W heads on 289? | 66 Racer | Classic Mustangs | 4 | 10-18-2001 03:12 AM |
| Edelbrock heads? | Coupe Devil | Windsor Power | 7 | 07-18-2001 03:58 PM |
| GT-40P heads? any good?? | acidangel316 | Windsor Power | 1 | 07-15-2001 10:26 PM |
| WINDSOR FORD HEADS ARE THEY ANY GOOD??? | joey50gt | Windsor Power | 4 | 03-22-2001 09:32 PM |