tranny cooler line kinked- solutions for fix
 

I kinked the last inch or so of my tranny cooler line when dropping an AODE.

Can this be repaired/spliced?
Any tips or solutions please.

You can probably just install a union in the line. Cut out the kink to where the line is round. If you have cut out more than the length of the union, you can either insert a short tube and 2 unions, or the whole line.

I've seen trans. shops just cut the lines upon removal if the fittings were rounded off or corroded so bad it wouldn't come apart.

------------------
'89 LX 5.0 - 5 speed. Original Owner
'94 E-150 4.9 Hi-Top Conversion Van

Unkink it. ;o)

------------------
-1989 GT, not stock.

-2000 Camaro SS-A4,
13.4's bone stock.

-1989 Chevy S-10, EX. Cab-383(500+hp on motor), tubbed, trick flow heads, trick flow pistons, etc... autometer phantom gauges, "built" 700R4, roll cage, lexan back window, corbeau seats, R.H.S. 5 harnesses, Fuel cell, convo pro wheels, 15x14's with 29x18.5 M/T'S on back, 15x4's on front, nitrous, and so much more!