Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-19-2002, 05:33 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: Seattle, WA
Posts: 381
|
Twin turbos on stock bottom end?
How much PSI could the stock bottom end handle?
Found a good TT kit for ~2800 and I am seriously considering it (http://membersites.namezero.com/team...ions/id12.html) Anything I should consider before ordering the kit from them? (Going to be a while anyways)... Thanks, DoranW
__________________
What I have: 1990 Red Mustang 5.0 LX: [BBK X-Pipe]-[MAC Cat-Back Exhaust] [MAC Cold Air Intake]-[BBK Equal Shorties] [3.55 Gears]-[Cobra Intake Manifold (Upper and Lower] [E-303 Cam]-[Granetelli Mass Air Flow Sensor] [Front and rear sway bars]-[New black carpet and seats.] [Adjustable Fuel Regulator]-[T5 Conversion w/ K. Cobra Clutch/Hurst STS] [Cobra Throttle Body]-[130A Alt. Conversion] Thinking about: Aftermarket Heads! Vortech A-Trim |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Should you run a solid lift cam with stock bottom | ciara | Windsor Power | 1 | 10-23-2003 11:12 AM |
| Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
| Underhood Conical K&N vs. Stock Airbox with K&N | jimberg | Windsor Power | 11 | 08-31-2001 02:36 PM |
| How much HP is too much??? The key is stock bottom end... | Piston | Windsor Power | 10 | 07-30-2001 04:37 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |