Typhoon Intake vs Edelbrock Performer RPM
 

I just bought a Typhoon Intake. Its on its way... I have read over and over again that the Typhoon and the RPM are virtually the same. I want to know if I can use the phenolic spacer kit for an Edelbrock Performer RPM with the Typhoon.

Good Article on the Typhoon:
http://www.fordmuscle.com/archives/2...ke/index.shtml

1989 Grand Marquis 302 Block

Bored .030 over

Sterling Hypereutectic Pistons

1969 351W Heads (30 hours of hand porting)

60cc combustion chambers machined to 50cc

~10.5:1 Compression Ratio

Ford Racing F-303 Cam

Sealed Power Hardened Pushrods

Sealed Power Valve Springs

TRW Guideplates

Clevite Studs (For Roller Rockers)

Cloyes Double-Roller Timing Chain

Harland Sharp 1.6 Ratio Roller Rockers

A9L Mass Air Computer

70MM Cobra MAF

Chromed Cold Air Intake Kit

24lb/hr Fuel Injectors

3.55 Posi Rearend

Mac Equal-Length Shorties

Mac Off-Road H-Pipe with Flowmasters

3" Cowl Hood

You should be able to... the typhoon is an exact copy of the edelbrock. Let me know what you think of it when you get it.

I want to buy the polished typhoon, just soon as I sell my cobra intake. But I heard the casting on them is not very good..?