BennyBoy

I ordered a 9" rear end from Currie with a Traction-Lok center section with 3.70 gears and 31-spline heavy duty axles/housings. I have the stock 8" open rear end with 3.00 gears in it right now with the stock driveshaft. My question is: Can I use my original driveshaft with the new rear end? Or what all will I have to do to make them work together? I'm in a state of urgency because it is going to be here any time along with my new heavy duty leaf springs! Please help! Thanks in advance!!!

------------------
'69 Coupe with 351W
=========================
Edelbrock RPM intake, Edelbrock RPM cam, Edelbrock 750 cfm carb, Edelbrock lifters, Edelbrock double roller timing chain, Edelbrock valve springs, Accel coil, Moroso Blue-Max wires, Hedman headers, 2 1/2" pipe, glasspacks, Flex fan, Lakewood traction bars, C4, 9" Currie on order, 290hp-stock heads
=========================
The Surgeon General didn't say anything about smoking your azz!!