© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-19-2002, 11:20 AM | #1 |
Registered Member
Join Date: Nov 2001
Location: germantown MD
Posts: 283
|
Valve Adjustment?
I have a hydraulic roller cam with pedestal mount rockers. Once I turn the crank so that lifter is on the base circle of the cam, I tighten the bolt to 17-23 ft/lbs? Is that all there is to it. Thats what I decyphered from a book I was reading. The book confused me by talking about useing a feeler gauge to check if the pushrods are the right length. I only have 50k miles and the pushrods don't have any visible wear, so I think I am ok with that. I just want to be sure. Is there anything else I should know about adjusting the valves? What is the best way to prime the lifters? How do I know if a lifter has gone bad?
__________________
85 GT 4bbl roller cam 2 ch. Flowmasters, O/R H-pipe Performer intake and carb milodon water pump, FMS 9mm wires, aluminum driveshaft, king cobra clutch |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Valve Adjustment | 89fast5oh | Windsor Power | 1 | 12-01-2003 08:01 AM |
Help with valve adjustment | mustangLX92 | Windsor Power | 0 | 11-07-2002 08:52 AM |
More On The Valve Adjustment | Wendell Allen | Classic Mustangs | 2 | 10-09-2002 07:29 AM |
Valve Adjustment Help - Puhleeze?? | Wendell Allen | Classic Mustangs | 6 | 10-07-2002 07:54 AM |
Valve adjustment | mustang_88gt | Windsor Power | 1 | 06-05-2001 09:31 PM |