© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-27-2004, 11:19 PM | #1 |
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
Valve cover question
I have a set of Motorsport aluminum covers, the tall ones with the red writing. I have a pcv valve in the drivers side cover, and a breather in the other one. The passenger side breather hits the drier and has caused dripping of oil onto the header. Do I really need the breather on the passenger side since I have the pcv valve, or can I get rid of it?
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
valve cover to TB hose?? | Simi Stang | Windsor Power | 11 | 12-22-2003 02:12 AM |
Is a valve cover breather bad for the 4.6???? | 96_4.6 | Modular Madness | 6 | 08-21-2003 06:38 PM |
A Valve Cover Story (long but gimme some pointers here) | Super_Stang | Windsor Power | 1 | 08-12-2001 07:29 AM |
simple valve cover question | clearwaterms | Windsor Power | 1 | 04-23-2001 07:18 PM |