Changing valve seals

exgmguy · 04-27-2001, 04:42 PM

Is there any trick to doing this on the car?
I was going to remove the rockers, fill the cylinder with air, remove the springs, then the seals should pry right out right?

Thanks,

Rob

04-27-2001, 05:15 PM

I think that just about covers it.

Do you think the seals are causing your slight smoking prob?

------------------
91 coupe
3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm
cobra intake,edelbrock heads,B303,1.72 rr's
36lb inj's,tremec, & a Paxton NOVI 2000!!!
11.020 @128.95 on BFG Drag Radials (275/60/15)

04-27-2001, 04:42 PM	#1
exgmguy Registered Member Join Date: Feb 1999 Location: Utica, Michigan Posts: 2,631	Changing valve seals Is there any trick to doing this on the car? I was going to remove the rockers, fill the cylinder with air, remove the springs, then the seals should pry right out right? Thanks, Rob

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Valve seals too tight?	Hozer 88GTConv	Windsor Power	0	03-09-2004 02:55 PM
valve seals	rtschoneman	Classic Mustangs	1	03-15-2003 04:19 PM
changing valve cover gaskets	HP400RW	Windsor Power	7	01-20-2003 12:56 PM
valve seals	89GTAtcoRaceway	Windsor Power	1	03-28-2002 09:04 PM
Valve guide seals?	Shotgun28	Windsor Power	1	03-13-2001 11:48 PM

04-27-2001, 05:15 PM	#2
SisuStang Guest Posts: n/a	I think that just about covers it. Do you think the seals are causing your slight smoking prob? ------------------ 91 coupe 3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm cobra intake,edelbrock heads,B303,1.72 rr's 36lb inj's,tremec, & a Paxton NOVI 2000!!! 11.020 @128.95 on BFG Drag Radials (275/60/15)