

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Jun 2002
Location: Edmonton, Alberta, Canada
Posts: 53
|
![]() I was looking for a 86-95 block that was used in a mustang and was hoping someone could direct me what the serial numbers on it would designate it being a HO block from a mustang. Thanks for the help!
|
![]() |
![]() |
![]() |
#2 |
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
![]() Just above the starter there will be a casting number. Look for E6ZE-6015-xx (xx could be any letters, it's the E6ZE that is important). Also acceptable are any blocks that contain E6*E-6015-xx (* being either an A, L, M, S, or V), and have "302" or "5.0L" cast into the lifter valley.
Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
Powerdyne Dyno numbers and continuing frustration | 1995MGTS | Windsor Power | 17 | 03-31-2002 12:59 PM |
How are these oil pressure numbers? | 88COBRA | Windsor Power | 3 | 02-26-2002 01:02 PM |
Intake Flow Numbers? anyone have them | NewAge 5.0 | Windsor Power | 0 | 09-25-2001 12:05 PM |
found a stang-need info | Will G | Windsor Power | 15 | 02-20-2001 12:45 PM |