Vortech mass air flow
 

I recently put on a Vortech mass air flow. in the box it came with to wires which look like they have resistors inside. They have blue conectors to splice into wires. I'm pretty sure they are for lowering or raising the vovltage somewhere, but not sure where. When i am driving it the check enging light comes on when I hit about 70 mph and doesn't go off till I turn off the car and then it comes on again at about 70 mph. Please help me find to where to put these wires.

Please help..


------------------
95 Yellow Mustang
Trick Flow R upper and lower intakes
Trick Flow Heads
TFS Cam
30 lb injectors
NX 150 hp kit w/ bottle warmer
255 lph intank pump
BBK 70mm throttle body
73mm Vortech Mass air
BBK Fuel Press Reg.
Borla side exhaust
Off road x-pipe
etc.etc.etc.


[This message has been edited by danjmorris (edited 02-24-2001).]

Are you talking about the sampling tubes? Or are there just extra wires? Sounds to me like you may wanna give Vortech a call and have them walk you through it.

------------------
1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s