MustangWorks.com : Ford Forums - View Single Post

PKRWUD · 08-30-2005, 05:14 PM

I would run a -8 AN line from the tank to the pump, a -8 AN line from the pump to a regulator, and two -6 AN lines from the regulator to the carb. If your pump and regulator were common, then you would need:

Fittings:
Four 3/8-NPT to -8 AN fittings (one at the tank, two on the pump, and one on the regulator)
Two 3/8-NPT to -6 AN fittings (both on the regulator)
Two 7/8-20 -6AN carb fittings (these screw into the bowls)

Line end fittings (for the ends of the hoses):
Four -8 AN fittings
Four -6 AN fittings

Some pumps and regulators require 1/2-NPT fittings rather than 3/8-NPT, so you would need to check first.

08-30-2005, 05:14 PM	#3
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	Re: what size fuel fittings I would run a -8 AN line from the tank to the pump, a -8 AN line from the pump to a regulator, and two -6 AN lines from the regulator to the carb. If your pump and regulator were common, then you would need: Fittings: Four 3/8-NPT to -8 AN fittings (one at the tank, two on the pump, and one on the regulator) Two 3/8-NPT to -6 AN fittings (both on the regulator) Two 7/8-20 -6AN carb fittings (these screw into the bowls) Line end fittings (for the ends of the hoses): Four -8 AN fittings Four -6 AN fittings Some pumps and regulators require 1/2-NPT fittings rather than 3/8-NPT, so you would need to check first. __________________ Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local RED & WHITE!