wheel studs-how to?
 

Hey all, I have these moser 28 spline rear axels that need wheel studs put in? Can someone tell me how that is done? Are they just banged in with a heavy hammer or do I need to have a special tool or maybe a proffesional do it for me.

Thanks as always,
PM

The moser just press in and out. You should be able to do it with a hammer just dont beat it to hard you don't want to bend anything. If these are for a high powered car you will also want to tac weld them to the axel. Mosers have been know to come lose.

Hope this helps.

I had other machining work done (redrill the front hubs for .625 knurl studs...) while I was at it...
But anyways, I _paid_ to get them pressfit in. It was like $2 each to pull out and push in.